FW-R2P

Dual bistable relay. 
Features of the module 
*Dual bistable relay; 
*Cooperation with remote control transmitters of the F&Wave system; 
*The ability to control from up to 8 transmitters; 
*Two local control inputs - the ability to directly control the relay using any monostable buttons (for example: bell buttons); 
*Two independent NO output contacts with load capacity of 4 A (AC-1) each (internally connected to L); 
*Small enclosure size; 
*Screw terminals for easy installation in a Ø60 flush-mounted box; 
*Retransmission of commands from the transmitter - the ability to increase the range of the remote control; 
*Low power consumption - low operating cost; 
*Built-in electronic thermal protection to prevent damage in case of excessive load of the controller. 

Technical data 
power supply 85÷265 V AC/DC 
control input 85÷265 V AC/DC; <1mA 
power consumption operating mode 1.00 W 
standby 0.25 W 
output load capacity (AC-1) 2× 4 A/250 V 
radio frequency 868 MHz 
working temperature -25÷65°C 
terminal 2.5mm² screw terminals 
tightening torque (max) 0.4 Nm 
mounting Ø60 flush-mounted box 
dimensions 48×43×20 mm 
ingress protection IP20 

Operating range In an open space without any interfering factors the range of the devices controlled by radio fluctuates within the limits of 100 m. The range can be improved by direct retransmission of modules located in mutual coverage area.